The Importance of Good Electrical Wiring and Components for Performance Cars
The Importance of Good Electrical Wiring and Components for Performance Cars
The electrical systems in regular civilian automobiles are extremely complicated. Simply getting the car to start and run could be considered a technological achievement. But with performance cars, that process is even more intricate.
Recently, Fine Line Imports encountered a 1971 Datsun 240Z fitting with a built Nissan JDM Skyline GTR RB26 JDM engine conversion, custom FLI turbo kit and fuel system. There was some electrical issue causing lower power and engine cutting out.
We removed the original hacked old Nissan GTR RB26 wire harness and replaced it with a brand-new reproduction. Not only did the engine make 80 to 100 more WHP and WTQ with 4 to 5 PSI less boost, but the cuts were gone.
Performance cars’ wiring and components differ from the electrical systems of standard vehicles because of a single goal: maximizing efficiency. It’s not enough to simply get the car to run—the objective is to get it to run as well as possible, for as long as possible. Below we’ll cover the importance of wiring and components in race cars.
What does a car’s electrical system control?
In short, basically everything. From the car’s battery to the starter and the alternator, its electrical wiring and components are vital to it functioning properly.
The car’s electrical system is also all interconnected, meaning an issue with one of the components mentioned above will impact the function of the related components. For example, a problem with the battery means the starter won’t work and the car won’t start.
How is the wiring in a performance car different than in a civilian car?
There are special considerations that need to be made when wiring a performance car. Performance cars’ wiring and components need to be selected and constructed with the optimization of the car’s efficiency in mind.
This could mean that the type of wiring you use would be different than in a normal car. According to a Motor Trend article, using TXL wire instead of SXL wire can make a car up to 6 pounds lighter due to TXL wiring’s thinner insulation. With a civilian automobile, making the car lighter isn’t as much of a concern.
What do you need to wire a performance car?
The importance of wiring and components in race cars necessitates the use of the correct tools. Below is a non-exhaustive list of tools you’ll need to wire a performance car’s electrical system:
- Wire strippers: A must-have for an electrician and those working with electrical components, wire strippers conveniently let you take insulation off of wires while saving the conductors within.
- Wire crimper: You can find top-of-the-line wire crimpers that have ratcheting capabilities or different sections for different lug sizes. A cheap tool used well would work fine, though. Try using the rounded part of the crimper to clamp on the split side of the connector while having the bump side of the crimper pushing in on the solid side of the terminal.
- Soldering iron: If you need to splice wires or secure larger connectors that can’t be crimped, a soldering iron will do the trick. Any type of electrical wiring work requires a soldering iron to make good connections, and performance cars are no exception.
- Wire brush: You can use this to clean off any oil, grease or corrosion prior to soldering.
- A volt/ohm meter: With this you can test your circuits and surmise their voltage level.
- Shrink tubing: Use this to insulate your connections from the exterior. The tubing can be fitted over connections, and shrinks when subjected to heat.
Call for your performance wiring today
If you need wiring and components for your performance car, call the team at Fine Line Imports. We offer specialty pars and full performance packages, and we’re dedicated to helping you optimize your ride.